šŸ› ļø What have you done to your F150 Tremor this week?

Changed the spark plugs
View attachment 48779
Didn’t look all that bad but I don’t have a feeler gauge and the sleeves were on all the new ones and undamaged. Boots looked fine and I cleaned them and the coil packs up w a dab of dialectic grease on the plug end.
View attachment 48780
Wasn’t all that hard to do besides the back ones were a lean over affair. Whoever decided to put a 2ā€ leveling kit on this truck needs to be sprayed in the face with brakleen :LOL:
I was just thinking about some new plugs, those with the copper crush washer instead of the conical seal are Indexed plugs like high performance engines. And I need to pick up a lighter torque wrench because the indexed plugs are set at 18ft-lbs. I didn’t know the boot could be cleaned up.
 
I was just thinking about some new plugs, those with the copper crush washer instead of the conical seal are Indexed plugs like high performance engines. And I need to pick up a lighter torque wrench because the indexed plugs are set at 18ft-lbs. I didn’t know the boot could be cleaned up.
I basically did what this guy did.
I just separated them from the coil packs and sprayed everything with this stuff then wiped it all down
IMG_4402.webp
Giving it ample time to dry out (it’s fast drying stuff) while I replace a whole side of plugs then I put it all together and install. I contemplated getting new boots but the parts guy, who I’ve known for a while, told me to inspect them first and they looked great. It’s a commuter mostly and I ain’t redlining it.
That stuff works good on older stuff too. I recently swapped a trans on my daughters Sbaru and it cleaned up the old dirty connections well.
 
Today was skid plate day, as my first real off-roading is coming this weekend to Anza Borrego. Between the curb on one side and a couple harbor freight ramps on the other getting this done was < 45 minutes. Sure would be nice if the truck at that tall to begin with!
IMG_1762.webp


IMG_1764.webp


IMG_1763.webp
 
Back
Top