What's new

🏕️ F150 Tremor Camping Forum!

Did a little tour of Alberta and British Columbia parks in the tent
 

Attachments

  • PXL_20250616_021541258.webp
    PXL_20250616_021541258.webp
    680.6 KB · Views: 95
  • PXL_20250609_222309479.webp
    PXL_20250609_222309479.webp
    717.6 KB · Views: 108
  • PXL_20250609_023004348.webp
    PXL_20250609_023004348.webp
    573.5 KB · Views: 90
  • PXL_20250608_011122495.webp
    PXL_20250608_011122495.webp
    332 KB · Views: 108
Tremor trek to Faucherie Falls, CA.
 

Attachments

  • 20250703_180124.webp
    20250703_180124.webp
    546.7 KB · Views: 72
  • 20250703_175959.webp
    20250703_175959.webp
    563.4 KB · Views: 66
  • 20250703_113708.webp
    20250703_113708.webp
    491.9 KB · Views: 67
  • 20250703_113531.webp
    20250703_113531.webp
    434.2 KB · Views: 60
  • 20250703_121427.webp
    20250703_121427.webp
    541.9 KB · Views: 65
A few sites from this year and last year.

I do post trip videos to YouTube (@GREYWOLFrv) but you do not have to watch or subscribe or anything. Just sharing.
 

Attachments

  • IMG_1596.webp
    IMG_1596.webp
    855.6 KB · Views: 42
  • IMG_1971.webp
    IMG_1971.webp
    463.9 KB · Views: 49
  • IMG_4005.webp
    IMG_4005.webp
    568.8 KB · Views: 46
  • IMG_3973.webp
    IMG_3973.webp
    627.5 KB · Views: 49
Went to Colorado again for some camping and off roading. Stayed in the Twin Lakes area and wheeled in the Leadville area. Really awesome trip! loved the Twin Lakes area - mountains and lakes are an awesome combo. Got some paddle boarding in too. unfortunately, the Micro Minnie flattened out the rear springs. I don't think my husband and I realized how much weight we had in the bed and on the hitch. Going to get new factory springs and either air bags or RAS.View attachment 22466View attachment 22467View attachment 22468View attachment 22469View attachment 22471View attachment 22481

Hey, fellow Micro Minnie FLX owner here. At my heaviest I have 120-lites of fuel in my bed, 100-lites of firewood, plus misc extra stuff and my truck rides level. I also see in these photos your truck is sitting perfectly fine without the trailer attache so I suspect you don’t have enough Weight Distribution (WD).

Without knowing your level of WD knowledge, the basics are:
- your ball-height should be ~2” higher than the top of the coupler
- with the trailer attached, the top of the front fender should be ⁺/₋ its original height.

Up means you could add a little more. Down means you have too much.

I also use a BlueOx SwayPro because it’s the only WD system on the market that is designed to flex. So when you/I/we’re going off-road, it’s not adding a bunch of extra WD when the tow vehicle pitches upward.
 
I don't know if Dometic is ending the product line or what, but a lot of huge discounts in the Camping section. Everything except for what I was looking at, the Water Jugs. The tables do look nice, especially at $55 down from $230
Take a peak:

1752869820349.webp
 
I don't know if Dometic is ending the product line or what, but a lot of huge discounts in the Camping section. Everything except for what I was looking at, the Water Jugs. The tables do look nice, especially at $55 down from $230
Take a peak:

View attachment 39993
Good post. I always seem to need a new table.
 
Awesome pics @JTTremor - What light bar are you running? How are you liking it?
 
13-hr driving and I needed to pull over for some rest. Found this little spot.
 

Attachments

  • IMG_4586.webp
    IMG_4586.webp
    102.6 KB · Views: 55
Found a nice spot in the Sierra Nevada's with no cell service for the dogs and I to set up for a little bit this week
View attachment 40017
How's that LP riding on your Tremor? I'm not seeing any rear-end squat from the weight. Did you modify the rear suspension, or is it stock? I just this weekend ordered one for my '23. Planning to wait until March for installation, though. Hoping by then they'll have all the bugs worked out of the new version.
 
How's that LP riding on your Tremor? I'm not seeing any rear-end squat from the weight. Did you modify the rear suspension, or is it stock? I just this weekend ordered one for my '23. Planning to wait until March for installation, though. Hoping by then they'll have all the bugs worked out of the new version.
Suspension is stock. Actually the suspension rides better now with the extra weight over the bed. I hated the suspension before getting the lone peak.
 
Suspension is stock. Actually the suspension rides better now with the extra weight over the bed. I hated the suspension before getting the lone peak.
Good to hear. Thanks!
 
Back
Top